Lightweight Render 9Kg

Lightweight Render 9Kg

Product Description 

Insulcon Lightweight Render is a 9kg bag factory blended, acrylic
render, suitable for application to a variety of building substrates.
These include masonary brick, block work, concrete panels, polystyrene
panels, blueboard/cement sheet & painted brick. Being very high in
polymer resin and extremely lightweight, this product is fast becoming
the preferred choice by tradesman.

Surface & Product Preparation

It is imperative that the substrate Insulcon Lightweight Render is to be applied to is totally clean
and removed of all loose particles, such as dirt, dust, etc. Failure to do so can cause delamination
resulting in damage to the finish product. Insulcon takes no responsibility for problems arising
from this. In a clean bucket add approx. 4-5 litres of clean water. Then whilst mixing with a
mechanical mixer, add contents of Insulcon Lightweight Render bag into the bucket. You may need
to add some more Insulcon Lightweight Render if you find the mixture to be too wet, or add some
more water if you find the mixture too dry. A nice paste mix is the desired finish to achieve
maximum results, both in finish and application. If the render is too wet, it can be very messy and
difficult to apply, resulting in hanging too long on the wall, making floating very hard and time
consuming. If the render is too dry then it will be very difficult to apply as it will not glide on the
wall and will tear when floating. This can also have an effect on drying time, resulting in a
compromised fast cured product.

Coverage

When Insulcon Lightweight Render is applied according to manufacturers instructions, it will cover
approx. 3 square metres on a 1st coat, and 5-6 square metres on a skim coat 2nd coat. Note -
These areas may vary depending on substrates and quality of substrates. Ideal application
thickness of 3-5mm for 1st coat is recommended. This may also vary depending on substrate.