Hi-Lite Plus Render 9Kg

Hi-Lite Plus Render 9Kg

Multipurpose Render

Product

Insulcon Hi Lite + Render is a 9kg bag factory blended, acrylic render, suitable for application to a variety of building substrates. These
include masonary brick, block work, concrete panels, polystyrene panels, blueboard/cement sheet, painted brick & dincel panel (when
prepared correctly). Being very high in polymer resin and extremely lightweight, this product is fast becoming the preferred choice by
tradesman.

Surface & Product Preparation

It is imperative that the substrate Insulcon Hi Lite + Render is to be applied to, is totally clean and removed of all loose particles, such as dirt, dust, etc. Failure to do so can cause delamination resulting in damage to the finish product. Insulcon takes no responsibility for problems arising
from this. In a clean bucket add approx. 4-5 litres of clean water.

Then whilst mixing with a mechanical mixer, add contents of Insulcon Hi Lite + Render bag into the bucket. You may need to
add some more render if you find the mixture to be too wet or add some more water if you find the mixture too dry.

A nice paste mix is the desired finish to achieve maximum results, both in finish and application. If the render is too wet, it can be very messy and difficult to apply, resulting in hanging too long on the wall, making floating very hard and time consuming. If the render is too
dry then it will be very difficult to apply as it will not glide on the wall and will tear when floating. This can also have an effect on drying time, resulting in a compromised fast cured product.

Coverage

When Insulcon Hi Lite + Render is applied according to manufacturers instructions, it will cover approx. 3 square metres on a 1st coat
Note - These areas may vary depending on substrates and quality of substrates. Ideal application
thickness of 3-5mm for 1st coat is recommended.

This may also vary depending on substrate.