Hi Build Render 15Kg

Hi-Build Render 15kg

• Product

Insulcon HiBuild is a 15kg bag factory blended, hi build acrylic render,
suitable for application to a variety of building substrates. These
include masonary brick, block work, concrete panels etc. Insulcon
HiBuild is ideal for those uneven substrates when normal render won’t
build out enough. Insulcon HiBuild can be built out to approx 30mm.
This must be done in stages to a maximum of 10mm per coat.
Note: Insulcon HiBuild is not recommended for use on cement
sheeting.

• Surface & Product Preparation

It is imperative that the substrate Insulcon Hi Build is to be applied to is totally clean and removed
of all loose particles, such as dirt, dust, etc. Failure to do so can cause delamination resulting in
damage to the finish product. Insulcon takes no responsibility for problems arising from this.
In a clean bucket add approx 3-4 litres of clean water. Then whilst mixing with a mechanical mixer,
add contents of Insulcon Hi Build bag into the bucket. You may need to add some more Insulcon Hi
Build if you find the mixture to be too wet or add some more water if you find the mixture too dry.
A nice paste mix is the desired finish to achieve maximum results, both in finish and application.
If the mixture is too wet, it can be very messy and difficult to apply, resulting in hanging too long
on the wall, making floating very hard and time consuming. If the mixture is too dry, then it will be
very difficult to apply as it will not glide on the wall and will tear when floating. This can also
influence drying time, resulting in a compromised fast cured product.

• Coverage

When Insulcon HiBuild is applied according to manufacturers instructions, Insulcon Hi Build will
cover approx 1.5-2.5 square metres at 8mm thickness. Note - These areas may vary depending on
substrates, quality of substrates and thickness applied.